Step 2B: Make Station Assignments On Ctx - Toshiba STRATA CTX Installation Manual

Installation
Step 2: Program CTX for the Console

Step 2B: Make Station Assignments on CTX

1. Enter Program 200, specify the Prime DN for this particular Attendant Console. The number
entered here is the DN used to reach this specific console. Do not use 0 as the Prime DN. Dial 0
is set in
another DKT or station.
2. Enter data for the FBs listed below:
4
"Create Dial 0 Destination" on page
Required. Set other FBs
according to site preferences.
FB01 – Specifies the equipment number (shelf/slot/port) required for assigning a new DN
to the system. Set the CTX Attendant Console DN to the PDKU or BDKU port (required).
FB02 – Press to assign the DKT Station type (required).

FB03 – Press to assign Extension (not Voice Mail) attributes to analog ports (required).

FB04 – Toshiba recommends entering COS 10 at the following three prompts:
"COS DAY1= ", "COS DAY2=

FB11 – Press (Dial Tone) to assign Dial Tone as the type of tone heard after LCR access

codes are dialed (required).
8. Do not assign the Attendant Console PDN to
Enter CTX Station DN
" and "COS Night=
 
Strata CTX Attendant Console Installation 03/03
Set to 10 unless you
assigned another COS
for the Attendant.
6443
" (preferred).