Show Authen Parameter; Enable Admin - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
4-26

show authen parameter

Description
This command is used to display the authentication parameters.
Format
show authen parameter
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the authentication parameters:
DGS-3620-28SC:admin# show authen parameter
Command: show authen parameter
Response Timeout : 60 seconds
User Attempts : 9
DGS-3620-28SC:admin#
4-27

enable admin

Description
This command is used to promote the "user" privilege level to "admin" level. When the user enters
this command, the authentication method TACACS, XTACAS, TACACS+, user-defined server
groups, local enable, or none will be used to authenticate the user. Because TACACS, XTACACS
and RADIUS don't support the enable function by themselves, if a user wants to use either one of
these three protocols to enable authentication, the user must create a special account on the
server host first, which has a username enable and then configure its password as the enable
password to support the "enable" function. This command cannot be used when authentication
policy is disabled.
Format
enable admin
Parameters
None.
76