D-Link xStack Reference Manual page 623

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
enable address_binding dhcp_snoop {[ipv6 | all]}
Parameters
ipv6 – (Optional) Specifies that the address used is an IPv6 address.
all – (Optional) Specifies that all IP addresses will be used.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the address binding DHCP snooping mode:
DGS-3620-28SC:admin#enable address_binding dhcp_snoop
Command: enable address_binding dhcp_snoop
Success.
DGS-3620-28SC:admin#
50-14 disable address_binding dhcp_snoop
Description
This command is used to disable address binding DHCP snooping. When DHCP snooping is
disabled, all of the auto-learned binding entries will be removed.
Format
disable address_binding dhcp_snoop {[ipv6 | all]}
Parameters
ipv6 – (Optional) Specifies that the address used is an IPv6 address.
all – Specifies that all IP addresses will be used.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable the address binding DHCP snooping mode:
DGS-3620-28SC:admin#disable address_binding dhcp_snoop
Command: disable address_binding dhcp_snoop
Success.
618