D-Link xStack Reference Manual page 190

Dgs-3620 series layer 3 managed stackable gigabit switch
Hide thumbs Also See for xStack:
Table of Contents

Advertisement

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
None. (EI Mode Only Command)
Example
To show network 10.108.0.0/16 advertised in the BGP updates:
DGS-3620-28SC:admin#
Command: show bgp network 10.108.0.0/16
Network Address
-----------------
10.108.0.0/16
Total Network Number:
DGS-3620-28SC:admin#
13-15 config bgp timer
Description
This command is used to configure the BGP protocol timer. The hold time needs to be at least
three times that of the keepalive time. If the timer is specified for specific neighbors, then the
neighbor specific timer will take effect.
Format
config bgp timer holdtime <sec 0-65535> keepalive <sec 0-65535>
Parameters
holdtime - The system will declare a peer as dead if a keepalive message is received that is
more than the hold time. The default value is 180 seconds. If the holdtime is set to zero, then
the holdtime will never expire. If the two routers that build a BGP connection have a different
hold time, then the smaller hold time will be used. If the timer is specified for specific
neighbors, then the neighbor specific timer will take effect. The hold time needs to be at least
three times that of the keepalive timer.
<sec 0-65535> - Enter the hold time value used here. This value must be between 0 and
65535.
keepalive - This specifies the interval at which keepalive messages are sent to its peer. If the
keepalive value is set to zero, then the keepalive message will not be sent out. The default
value is 60 seconds. If the two routers that build a BGP connection have a different keepalive
timer, then the smaller keepalive timer will be used. If the timer is specified for specific
neighbors, then the neighbor specific timer will take effect.
<sec 0-65535> - Enter the keep-alive time value used here. This value must be between 0
and 65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
show bgp network 10.108.0.0/16
Route Map
-------------
-
1
185

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xstack dgs-3620-28sc

Table of Contents