D-Link xStack Reference Manual page 713

Dgs-3620 series layer 3 managed stackable gigabit switch
Hide thumbs Also See for xStack:
Table of Contents

Advertisement

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Success.
DGS-3620-28SC:admin#
58-1
config loopdetect vlan
Description
This command is used to setup the loop-back detection function for the VLANs on VLAN-based
mode.
Format
config loopdetect vlan [<vid_list> | all] state [enable | disable]
Parameters
vlan - Specifies the VLAN(s).
<vid_list> - Enter the VLAN list.
all - Specifies that all VLANs will be used for this configuration.
state - Specifies whether the LBD function should be enabled or disabled on the VLANs
specified.
enable - Specifies that the LBD function will be enabled.
disable - Specifies that the LBD function will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the LBD function on VLANs 2 to 5:
DGS-3620-28SC:admin#config loopdetect vlan 2-5 state enable
Command: config loopdetect vlan 2-5 state enable
Success.
DGS-3620-28SC:admin#
708

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xstack dgs-3620-28sc

Table of Contents