Config Syslog Host - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28SC:admin#show syslog
Command: show syslog
Syslog Global State: Enabled
DGS-3620-28SC:admin#

71-15 config syslog host

Description
This command is used to configure the syslog host configuration.
Format
config syslog host [<index 1-4> | all] {severity [emergency | alert | critical | error | warning |
notice | informational | debug| <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress [<ipaddr> | <ipv6addr>] |
state [enable | disable]}(1)
Parameters
<index 1-4> - Enter the host index.
all - Specifies all hosts.
severity - (Optional) Specify the severity level supported: emergency, alert, critical, error,
warning, notice, informational, or debug.
emergency - Specifies emergency messages.
alert - Specifies alert messages.
critical - Specifies critical messages.
error - Specifies error messages.
warning - Specifies warning messages.
notice - Specifies notice messages.
informational - Specifies informational messages.
debug - Specifies debug messages.
<level 0-7> - Enter a level between 0 and 7.
facility - Some of the operating system daemons and processes have been assigned facility
values. Processes and daemons that have not been explicitly assigned a facility may use any
of the"local use" facilities or they may use the "user-level" facility. Those facilities that have
been designated are shown in the following:
local0 - User-defined facility.
local1 - User-defined facility.
local2 - User-defined facility.
local3 - User-defined facility.
local4 - User-defined facility.
local5 - User-defined facility.
local6 - User-defined facility.
local7 - User-defined facility.
udp_port - Specifies the UDP port number.
<udp_port_number> - Enter the UDP port number.
ipaddress - Specifies the IPv4 address or IPv6 address of the host.
<ipaddr> - Enter the IPv4 address of the host.
<ipv6addr> - Enter the IPv6 address of the host.
state - The syslog protocol has been used for the transmission of event notification messages
819