Debug Stp Show Flag - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
debug stp show counter {ports [<portlist> | all]}
Parameters
ports - (Optional) Specifies the STP ports for display.
<portlist> - Enter the list of port used for this configuration here.
all - Display all port's counters.
If no parameter is specified, display the global counters.
Restrictions
Only Administrator level users can issue this command.
Example
To show the STP counters for port 9:
DGS-3620-28SC:admin#debug stp show counter ports 9
Command: debug stp show counter ports 9
STP Counters
--------------------------------------
Port 9 :
Receive:
Total STP Packets
Configuration BPDU
TCN BPDU
RSTP TC-Flag
RST BPDU
Discard:
Total Discarded BPDU
Global STP Disabled
Port STP Disabled
Invalid packet Format
Invalid Protocol
Configuration BPDU Length : 0
TCN BPDU Length
RST BPDU Length
Invalid Type
Invalid Timers
CTRL+C ESC q Quit

21-12 debug stp show flag

Description
This command used to display the STP debug level on specified ports.
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
SPACE n Next Page p
Transmit:
Total STP Packets
Configuration BPDU : 0
TCN BPDU
RSTP TC-Flag
RST BPDU
Previous Page r Refresh
313
: 0
: 0
: 0
: 0