Show Ipif - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
11-6

show ipif

Description
This command is used to display IP interface settings.
Format
show ipif {<ipif_name 12>}
Parameters
<ipif_name 12> - (Optional) The name of the interface.
Restrictions
None.
Example
To display IP interface settings:
DGS-3620-28SC:admin#show ipif
Command: show ipif
IP Interface
VLAN Name
Interface Admin State
IPv4 Address
Proxy ARP
IP Directed Broadcast
IPv4 State
DHCPv6 Client State
DHCPv6 Client PD State
IPv6 State
IP MTU
IP Interface
Status
IP Address
Subnet Mask
Gateway
Link Status
Total Entries: 2
DGS-3620-28SC:admin#
11-7 config out_band_ipif
Description
This command is used to configure the out of band management port settings.
: System
: default
: Enabled
: 10.90.90.90/8 (Manual)
: Disabled (Local : Disabled)
: Disabled
: Enabled
: Disabled
: Disabled
: Enabled
: 1500
: mgmt_ipif
: Enabled
: 192.168.0.1
: 255.255.255.0
: 0.0.0.0
: Link Down
162
Primary