D-Link xStack Reference Manual page 163

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
vlan - (Optional) The name of the VLAN corresponding to the IP interface.
<vlan_name 32> - Enter the VLAN name. The maximum length is 32 characters.
state - Enable or disable the IP interface.
enable - Enable the IP interface.
disable - Disable the IP interface.
proxy_arp - (Optional) Enable or disable the proxy ARP. This is for the IPv4 function. The default
is disabled.
enable - Enable the proxy ARP.
disable - Disable the proxy ARP.
local - (Optional) This setting controls whether the system provides the proxy reply for the ARP
packets destined for IP addresses located in the same interface as the received interface.
When proxy ARP is enabled for an interface, the system will do the proxy reply for the ARP
packets destined for IP addresses located on a different interface. For ARP packets destined
for IP address located on the same interface, the system will check this setting to determine
whether to reply. The default is disabled.
enable - Enable the local proxy ARP function.
disable - Disable the local proxy ARP function.
bootp - Allows the selection of the BOOTP protocol for the assignment of an IP address to the
switch's System IP interface.
dhcp - Allows the selection of the DHCP protocol for the assignment of an IP address to the
switch's System.
ipv6 - The following are IPv6-related parameters.
ipv6address - The IPv6 address and subnet prefix of the IPV6 address to be created.
prefix_name - Specifies the IPv6 prefix name.
<string 1-12> - Enter the IPv6 prefix name. This name can be up to 12 characters long.
<ipv6networkaddr> - The IPv6 address and subnet prefix of the IPV6 address to be
created.
state - Enable or disable the IPv6 state of the IP interface.
enable - Enable the IPv6 state of the IP interface.
disable - Disable the IPv6 state of the IP interface.
ip_mtu - Specifies the IP Layer MTU value used.
<value 512-1712> - Enter the IP Layer MTU value used here. The value must be between
512 and 1712.
ipv4 state - The state of the IPv4 interface.
enable - Enable the IPv4 state of the IP interface.
disable - Disable the IPv4 state of the IP interface.
dhcpv6_client - Specifies the DHCPv6 client state of the interface.
enable - Specifies that the DHCPv6 client state of the interface will be enabled.
disable - Specifies that the DHCPv6 client state of the interface will be disabled.
ip_directed_broadcast - Specifies the IP directed-broadcast state of the interface.
enable - Specifies that the IP directed-broadcast state of the interface will be enabled.
disable - Specifies that the IP directed-broadcast state of the interface will be disabled.
dhcpv6_client_pd - Specifies the DHCPv6 client PD configuration.
enable - Specifies to enable the DHCPv6 client PD state of the interface.
prefix_name - Specifies an alias name for the prefix requested from the delegation router. If
disable the DHCPv6 client PD the name will be automatic clear.
<string 1-12> - Enter the prefix alias name. This name can be up to 12 characters long.
disable - Specifies to disable the DHCPv6 client PD state of the interface.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the System IP interface:
DGS-3620-28SC:admin#config ipif System vlan v1
158