D-Link xStack Reference Manual page 52

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config radius <server_index 1-3> {ipaddress [<server_ip> |<ipv6addr>] | [key <password
32> | encryption_key <password 56>] | auth_port [<udp_port_number 1-65535> | default] |
acct_port [<udp_port_number 1-65535> | default] | timeout [<sec 1-255> | default] |
retransmit [<int 1-20> | default]}
Parameters
<server_index 1-3> - Enter the RADIUS server index.
ipaddress - Specifies the IP address of the RADIUS server.
<server_ip> - Enter the RADIUS server IP address here.
<ipv6addr> - Enter the IPv6 address here.
key - Specifies the key pre-negotiated between the switch and the RADIUS server. It is used to
encrypt user's authentication data before being transmitted over the Internet. The maximum
length of the key is 32.
<passwd 32> - Enter the key pre-negotiated between the switch and the RADIUS server. It is
used to encrypt user's authentication data before being transmitted over the Internet. The
maximum length of the key is 32.
encryption_key - (Optional) Specifies the key pre-negotiated between the switch and the
RADIUS server. It is used to encrypt the user's authentication data before being transmitted
over the Internet.
<password 56> - Enter the enryption key.
auth_port - Specifies the UDP port number which is used to transmit RADIUS authentication
data between the switch and the RADIUS server. The default is 1812.
<udp_port_number 1-65535> - The authentication port value must be between 1 and 65535.
default - Specifies to use the default value.
acct_port - Specifies the UDP port number which is used to transmit RADIUS accounting
statistics between the switch and the RADIUS server. The default is 1813.
<udp_port_number 1-65535> - The accounting statistics value must be between 1 and
65535.
default - Specifies to use the default value.
timeout - Specifies the time in seconds for waiting for a server reply. The default value is 5
seconds.
<int 1-255> - Enter the time in seconds for waiting for a server reply. The timeout value must
be between 1 and 255. The default value is 5 seconds.
default - Specifies to use the default value.
retransmit - Specifies the count for re-transmission. The default value is 2.
<int 1-20> - The re-transmit value must be between 1 and 20.
default - Specifies to use the default value.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a RADIUS server:
DGS-3620-28SC:admin#config radius 1 ipaddress 10.48.74.121 key dlink
Command: config radius 1 ipaddress 10.48.74.121 key dlink
Success.
DGS-3620-28SC:admin#
47