D-Link xStack Reference Manual page 199

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28SC:admin#
Command: delete bgp neighbor 10.10.10.2
Success.
DGS-3620-28SC:admin#
13-22 config bgp neighbor
Description
This command is used to configure the BGP neighbor's description or password attribute.
Format
config bgp neighbor [<ipaddr> | peer_group <peer_group_name 16>] [description <desc
80> | clear_description | password <password 25> | clear_password]
Parameters
<ipaddr> - Specifies the IP address of the neighbor to be configured.
peer_group - Specifies the peer group to be configured.
<peer_group_name 16> - Enter the peer group name here. This name can be up to 16
characters long.
description - Associate a description with a neighbor. By default, the description is not specified.
<desc 80> - Enter the description value used here. This value can be up to 80 characters
long.
clear_description - Removes the neighbor's description.
password - Specifies to set the MD5 authentication password when a TCP connection between
BGP neighbors are established. When BGP neighbors are created, password aren't set by
default.
<password 25> - Enter the password used here. This password can be up to 25 characters
long.
clear_password - Specifies to clear the MD5 authentication password when a TCP connection
between BGP neighbors are established.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To configure a neighbor's description:
DGS-3620-28SC:admin#
Command: config bgp neighbor 10.10.10.2 description EBGP-neighbor
Success.
DGS-3620-28SC:admin#
delete bgp neighbor 10.10.10.2
config bgp neighbor 10.10.10.2 description EBGP-neighbor
194