Delete Authen Server_Host <Ipaddr> Protocol [Tacacs | Xtacacs | Tacacs+ | Radius] - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
seconds.
<int 1-255> - Enter the time in seconds for waiting for a server reply. The default value is 5
seconds. The timeout value must be between 1 and 255 seconds.
retransmit - Specifies the count for re-transmit. This value is meaningless for TACACS+. The
default value is 2.
<int 1-20> - Enter the count for re-transmit. This value is meaningless for TACACS+. The
default value is 2. The re-transmit value must be between 1 and 20.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure a TACACS+ authentication server host's key value:
DGS-3620-28SC:admin#config authen server_host 10.1.1.222 protocol tacacs+ key
"abc123"
Command: config authen server_host 10.1.1.222 protocol tacacs+ key "abc123"
Success.
DGS-3620-28SC:admin#
4-22 delete authen server_host
Description
This command is used to delete an authentication server host.
Format
delete authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
Parameters
<ipaddr> - Enter the server host's IP address.
protocol - Specifies the server host's type of authentication protocol.
tacacs - Specifies the server host's authentication protocol TACACS.
xtacacs - Specifies the server host's authentication protocol XTACACS.
tacacs+ - Specifies the server host's authentication protocol TACACS+.
radius - Specifies the server host's authentication protocol RADIUS.
Restrictions
Only Administrator-level users can issue this command.
Example
To delete an authentication server host:
DGS-3620-28SC:admin#delete authen server_host 10.1.1.222 protocol tacacs+
Command: delete authen server_host 10.1.1.222 protocol tacacs+
73