D-Link xStack Reference Manual page 451

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
27-15 show dhcpv6_server
Description
This command is used to display the DHCPv6 server setting.
Format
show dhcpv6_server {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specifies the IP interface name to be displayed.
<ipif_name 12> - Enter the IP interface name to be displayed here. This name can be up to
12 characters long.
Restrictions
None.
Example
To display the DHCPv6 server setting:
DGS-3620-28SC:admin# show dhcpv6_server
Command: show dhcpv6_server
DHCPv6 Server Global State: Disabled
---------------------------------------------------------------
IP Interface
DHCPv6 Server State
IP Interface
DHCPv6 Server State
Total Entries : 2
DGS-3620-28SC:admin#
27-16 config dhcpv6 pool excluded_address
Description
This command is used to configure the reserved IPv6 addresses on the DHCPv6 server.
Format
config dhcpv6 pool excluded_address <pool_name 12> [add begin <ipv6addr> end
<ipv6addr> | delete [begin <ipv6addr> end <ipv6addr> | all]]
Parameters
<pool_name 12> - Enter the DHCPv6 pool name used here. This name can be up to 12
: System
: Enabled
: ipif1
: Enabled
446