D-Link xStack Reference Manual page 205

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
characters long.
state - The specified neighbor will become the router reflector client. By default, this state is
disabled.
enable - Specifies that the neighbor will become the router reflector client.
disable - Specifies that the neighbor will not become the router reflector client.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example shows how to add a neighbor as the route reflector client:
DGS-3620-28SC:admin#
state enable
Command: config bgp neighbor route_reflector_client
Success.
DGS-3620-28SC:admin#
13-27 config bgp neighbor map
Description
The command is used to configure the route map related setting for a BGP neighbor. When a
route map is applied by the route_map command, it enforces the route policy. When it is applied
by the unsuppress_map command, the suppressed route which matches the permit rule will be
unsuppressed. It provides a manipulation of routers per neighbor. If a route map is configured
relating to a BGP neighbor but the route map doesn't exist, it means deny any. If the route map
exists but has no filter entry defined, it will permit all.
Format
config bgp neighbor map [<ipaddr> | peer_group <peer_group_name 16>]
{unsuppress_map [add | delete] <map_name 16> | route_map [in | out] [add | delete]
<map_name 16>}(1)
Parameters
<ipaddr> - Specifies the IP address of the neighbor to be configured.
peer_group - Specifies the peer group to be configured.
<peer_group_name 16> - Enter the peer group name here. This name can be up to 16
characters long.
unsuppress_map - (Optional) Name of a route map used to selectively advertise routers
previously suppressed by the aggregate_address command.
add - Specifies that a route map will be added.
delete - Specifies that a route map will be deleted.
<map_name 16> - Enter the unsurpress map name here. This name can be up to 16
characters long.
route_map - (Optional) Specify the route map to be applied to the incoming or outgoing routes.
in - Specifies the incoming routes from the neighbor.
config bgp neighbor route_reflector_client
200
10.10.10.2
10.10.10.2 state enable