D-Link xStack Reference Manual page 197

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
remote_as - The number of autonomous systems to which the peer group belongs to.
<as_number 0-4294967295> - Enter the remote AS value here. This value must be between
0 and 4294967295.
add - Specifies to add an IP address.
delete - Specifies to delete an IP address.
<ipaddr> - Enter the IP address to be added or deleted here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To delete a member from the peer group named local:
DGS-3620-28SC:admin#
Command: config bgp peer_group local delete 10.2.2.2
Success.
DGS-3620-28SC:admin#
To set a peer group named local remote_as to 50:
DGS-3620-28SC:admin#
Command: config bgp peer_group local remote_as 50
Success.
DGS-3620-28SC:admin#
13-20 create bgp neighbor
Description
The command is used to create a BGP neighbor. Either a single router or a peer group can be
created as neighbor.
If the created neighbor has a single IP address, the remote AS must be specified. A peer group
must be specified of which this BGP speaking neighbor belongs to, and in this condition, a remote
AS must be specified to the peer group first.
If the created neighbor is a peer group, then the remote AS cannot be specified here. The remote
AS must specified by using the "config peer_group remote_as" command.
Format
create bgp neighbor [<ipaddr> [remote_as <as_number 1-4294967295> | peer_group
<peer_group_name 16>] | peer_group <peer_group_name 16>]
Parameters
<ipaddr> - Enter the IP address of the BGP speaking neighbor here.
config bgp peer_group local delete 10.2.2.2
config bgp peer_group local remote_as 50
192