Config Temperature - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28SC:admin#show environment
Command: show environment
Internal Power
External Power
Current Temperature(Celsius) :
High Warning Temperature Threshold(Celsius) :
Low Warning Temperature Threshold(Celsius)
CTRL+C ESC q Quit
2-10

config temperature

Description
This command is used to configure the warning trap or log state of the system internal temperature.
Format
config temperature [trap | log] state [enable | disable]
Parameters
trap - Specifies to configure the warning temperature trap.
log - Specifies to configure the warning temperature log.
state - Enable or disable either the trap or log state for a warning temperature event. The default
is enable.
enable - Enable either the trap or log state for a warning temperature event.
disable - Disable either the trap or log state for a warning temperature event.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable the warning temperature trap state:
DGS-3620-28SC:admin#config temperature trap state enable
Command: config temperature trap state enable
Success.
DGS-3620-28SC:admin#
To enable the warning temperature log state:
DGS-3620-28SC:admin#config temperature log state enable
Command: config temperature log state enable
Success.
DGS-3620-28SC:admin#
: Active
: Fail
56
SPACE n Next Page p
79
: 11
Previous Page r Refresh
17