D-Link xStack Reference Manual page 204

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
default - Specifies that the default AS original interval value will be used.
connect - (Optional) Minimum interval BGP sends TCP connect requests to the peer after a TCP
connection fail happens. The default setting is 120 seconds.
<sec 1-65535> - Enter the minimum interval BGP sends TCP connect requests to the peer
after a TCP connection fail happens value here. This value must be between 1 and 65535.
default - Specifies that the default connect value will be used.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example shows how to configure the advertisement interval to 20 seconds:
DGS-3620-28SC:admin#
advertisement_interval 20
Command: config bgp neighbor timer peer_group Campus
Success.
DGS-3620-28SC:admin#
13-26 config bgp neighbor route_reflector_client
Description
This command is used to configure the BGP's neighbor of the route reflector client. When the route
reflector client is defined and the router reflection is enabled, the BGP router will act as the route
reflector. The reflector and its client form a cluster. In a cluster, all the members must be iBGP
connections with the reflector and vice versa. The reflector is the representative of the cluster. For
the reflector, the iBGP connection is established by the "create bgp neighbor" command and the
corresponding neighbor must be specified as the client by this command. For the client, the iBGP
connection is established by the "create bgp neighbor" command.
When the router is in reflection mode, the router will exchange information with client neighbors in
the reflection way and with the remaining neighbor in the ordinary way.
When the router is in non-reflection mode, the router will exchange information with all the
neighbors in the non-reflection way.
An AS can have multiple clusters, and a cluster can have more than one reflector for redundancy
purposes.
Format
config bgp neighbor route_reflector_client [<ipaddr> | peer_group <peer_group_name 16>]
state [enable | disable]
Parameters
<ipaddr> - Specifies the IP address of the neighbor to be configured.
peer_group - Specifies the peer group to be configured.
<peer_group_name 16> - Enter the peer group name here. This name can be up to 16
config bgp neighbor timer peer_group Campus
199
advertisement_interval 20