D-Link xStack Reference Manual page 232

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
This example configures the BGP scan timer to 30 seconds:
DGS-3620-28SC:admin#
Command: config bgp scan_timer 30
Success.
DGS-3620-28SC:admin#
13-54 config bgp aggregate_next_hop_check
Description
This command is used to configure the BGP aggregated routes' next hop check. Only the routes
with the same next hop attribute can be aggregated if the BGP aggregate next hop check is
enabled.
Format
config bgp aggregate_next_hop_check [enable | disable]
Parameters
enable - Specifies that the BGP aggregate next hop check will be enabled.
disable - Specifies that the BGP aggregate next hop check will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This is an example of configuring the BGP aggregate next hop check:
DGS-3620-28SC:admin# config bgp aggregate_next_hop_check enable
Command: config bgp aggregate_next_hop_check enable
Success.
DGS-3620-28SC:admin#
13-55 config bgp fast_external_fallover
Description
This command configures a Border Gateway Protocol (BGP) routing process to immediately reset
its external BGP peer sessions if the link used to reach these peers goes down,
Format
config bgp fast_external_fallover [enable | disable]
config bgp scan_timer 30
227