D-Link xStack Reference Manual page 508

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28SC:admin#dir c:/system
Command: dir c:/system
System reserved directory. Used space 89KB.
DGS-3620-28SC:admin#
38-6 rename
Description
This command is used to rename a file in the file system. The pathname specifies the file (in path
form) to be renamed and the file name specifies the new file name. If the path name is not a full
path, then it refers to a path under the current directory for the drive. The renamed file will stay in
the same directory.
Format
rename {{unit <unit_id>} <drive_id>} <pathname> <filename>
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Enter the file (in path form) to be renamed.
<filename> - Enter the new name of the file.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To rename a file or directory:
DGS-3620-28SC:admin#rename run.had run1.had
Command: rename run.had run1.had
Success.
DGS-3620-28SC:admin#
38-7 erase
Description
This command is used to delete a file stored in the file system. The system will prompt if the target
file is a bootup image/configuration or the last image.
Format
erase {{unit <unit_id>} <drive_id>} <pathname>
503