D-Link xStack Reference Manual page 188

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<network_address> - Represents the local network that BGP will advertise.
route_map - (Optional) Specifies the route map to be applied to the advertised networks. If not
specified, all networks are advertised.
<map_name 16> - Enter the route map name here. This name can be up to 16 characters
long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
Setup network 10.108.0.0/16 to be included in the BGP updates:
DGS-3620-28SC:admin#
Command: create bgp network 10.108.0.0/16
Success.
DGS-3620-28SC:admin#
13-12 config bgp network
Description
This command is used to configure the attribute associated with the network advertised by the
Border Gateway Protocol (BGP).
Format
config bgp network <network_address> [route_map <map_name 16> | clear_routemap]
Parameters
<network_address> - Represents the local network that BGP will advertise.
route_map - Specifies the route map applied to the advertised networks.
<map_name 16> - Enter the route map name here. This name can be up to 16 characters
long.
clear_routemap - Removes the route map applied to the network.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
Change the network 10.108.0.0/16 to clear a route map:
create bgp network 10.108.0.0/16
183