D-Link xStack Reference Manual page 436

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
ipif - Specifies the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all - Specifies that all the configured IP interfaces wil be used..
state - Specifies if the DHCPv6 relay state will be enabled or disabled.
enable - Choose this parameter to enable the DHCPv6 relay state of the interface.
disable - Choose this parameter to disable the DHCPv6 relay state of the interface.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the DHCPv6 relay state of the System interface to enable:
DGS-3620-28SC:admin#
Command: config dhcpv6_relay ipif System state enable
Success.
DGS-3620-28SC:admin#
26-6 show dhcpv6_relay
Description
This command will display the current DHCPv6 relay configuration of all interfaces, or if an IP
interface name is specified, the DHCPv6 relay configuration for that IP interface.
Format
show dhcpv6_relay {ipif <ipif_name 12>}
Parameters
ipif - (Optional) The name of the IP interface for which to display the current DHCPv6 relay
configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
If no IP interface is specified, all configured DHCPv6 relay interfaces are displayed.
Restrictions
None.
Example
To show the DHCPv6 relay configuration of all interfaces:
config dhcpv6_relay ipif System state enable
431