D-Link xStack Reference Manual page 356

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
enable - Enable the route_map debug function.
disable - Disable the route_map debug function.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure routemap debug flags' state to enable:
DGS-3620-28SC:admin#
Command: debug bgp router_map enable
Success.
DGS-3620-28SC:admin#
Command: config bgp neighbor map 15.0.0.1 route_map in add map1
Success.
DGS-3620-28SC:admin#
Output Examples: After configure BGP to enable route map debug flag, it may print following
information when route map applied.
route_map:<map1>,apply bgp neighbor:<13.0.0.1> MATCH.
route_map:<map1>,apply bgp static route:<32.0.0.0/8> Not MATCH.
21-54 debug bgp access_list
Description
This command is used for setting access_list debugging flags to disable or enable. If this flag is
enable, access list permit or deny in BGP module will be displayed
Format
debug bgp access_list [enable | disable]
Parameters
enable - Enable the access_list debug function.
disable - Disable the access_list debug function.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
debug bgp router_map enable
config bgp neighbor map 15.0.0.1 route_map in add map1
351