D-Link xStack Reference Manual page 200

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
13-23 config bgp neighbor session
Description
The command is used to configure the state or neighbor's session activity for a BGP neighbor. If a
neighbor is specified to be in the disabled state, it is equivalent to the case that the neighbor is
deleted except when the neighbor configuration is kept.
Format
config bgp neighbor session [<ipaddr> | peer_group <peer_group_name 16>] [activity |
state] [enable | disable]
Parameters
<ipaddr> - Specifies the IP address of the neighbor to be configured.
peer_group - Specifies the peer group to be configured.
<peer_group_name 16> - Enter the peer group name here. This name can be up to 16
characters long.
state - If state is changed from enabled to disabled, the session with the neighbor peer will be
terminated.
activity - Specifies the state for individual address family. By default, the setting is enabled for
IPv4 address family.
enable - Specifies that the neighbor session state or the for individual address family state will be
enabled.
disable - Specifies that the neighbor session state or the for individual address family state will
be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example will shut down all the neighbors that are contained in the peer group "Campus":
DGS-3620-28SC:admin# config bgp neighbor session peer_group Campus state
disable
Command: config bgp neighbor session peer_group Campus state disable
Success.
DGS-3620-28SC:admin#
This example shuts down the activity state of the neighbor 10.90.90.90:
DGS-3620-28SC:admin#
Command: config bgp neighbor session 10.90.90.90 activity disable
Success.
DGS-3620-28SC:admin#
config bgp neighbor session 10.90.90.90 activity disable
195