D-Link xStack Reference Manual page 184

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To configure the BGP process's router ID:
DGS-3620-28SC:admin#
Command: config bgp router_id 10.10.10.1
Success
DGS-3620-28SC:admin#
13-6 config bgp synchronization
Description
This command is used to configure the BGP synchronization ability. Usually, a BGP speaker does
not advertise a route to an external neighbor unless that route is local or exists in the IGP. By
default, synchronization between BGP and the IGP is turned off to allow the BGP to advertise a
network route without waiting for route validation from the IGP. This feature allows routers and
access servers within an Autonomous System to have the route before BGP makes it available to
other autonomous systems.
Format
config bgp synchronization [enable | disable]
Parameters
enable - Specifies to enable synchronization.
disable - Specifies to disable synchronization. By default, this setting is disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To enable the BGP process' synchronization ability:
DGS-3620-28SC:admin#
Command: config bgp synchronization enable
Success
DGS-3620-28SC:admin#
13-7 config bgp enforce_first_as
Description
This command is used to enforce the neighbor's AS as the first AS in the AS list.
config bgp router_id 10.10.10.1
config bgp synchronization enable
179