D-Link xStack Reference Manual page 210

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
13-31 config bgp client_to_client_reflection
Description
This command is used to configure the BGP client to client reflection setting. If the reflection is
disabled, then the router will not reflect routes from the route reflect client to other route reflect
clients, but it will still send routes received from a non-reflecting client to a reflecting client.
Format
config bgp client_to_client_reflection [enable | disable]
Parameters
enable - The reflector will operate in reflector mode.
disable - The reflector will operate in non-reflector mode.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example shows how to disable the client to client reflection:
DGS-3620-28SC:admin#
Command: config bgp client_to_client_reflection disable
Success.
DGS-3620-28SC:admin#
13-32 config bgp confederation identifier
Description
This command is used to configure the BGP confederation. A confederation, which is represented
by an AS, is a group of the sub AS.
A confederation can be used to reduce the internal BGP (iBGP) mesh by dividing a large single AS
into multihop sub AS. External peers interact with the confederation as if it is a single AS.
Each sub AS is fully meshed within itself and it has connections to other sub AS within the
confederation. The next hop, Multi Exit Discriminator (MED), and local preference information is
preserved throughout the confederation, allowing you to retain a single Interior Gateway Protocol
(IGP) for all the autonomous systems.
Format
config bgp confederation identifier <as_number 0-4294967295>
config bgp client_to_client_reflection disable
205