D-Link xStack Reference Manual page 936

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
route_preference - (Optional) Specifies the priority of this policy route. By default, the policy
route has higher priority than the routing table, including local, default, static, and dynamic
routes. The one that has the higher priority should be used to check the traffic first.
default - Specifies that the policy base route has lower priority than the route in the routing
table.
pbr - Specifies that the policy base route has higher priority than the route in the routing table.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure all packets which match ACL rule profile ID=1 and access ID=1, and then route to
20.1.1.100:
DGS-3620-28SC:admin#config policy_route name danillo acl profile_id 1 access_id
1 nexthop 20.1.1.100 state enable
Command: config policy_route name danillo acl profile_id 1 access_id 1 nexthop
20.1.1.100 state enable
Success.
DGS-3620-28SC:admin#
79-4 show policy_route
Description
This command is used to display the switch's current policy route rules.
Format
show policy_route
Parameters
None.
Restrictions
None.
Example
To display the switch's current policy route rules:
931