Show Cfm Fault - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
md_index - Specifies the maintenance domain index.
<uint 1-4294967295> - Enter the maintenance domain index value here. This value must
be between 1 and 4294967295.
ma - (Optional) Specify the maintenance association name.
<string 22> - Enter the maintenance association name. The maximum length is 22
characters.
ma_index - Specifies the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must be between 1 and 4294967295.
mepid - (Optional) Specify the MEPID.
<int 1-8191> - Enter the MEP MEPID between 1 and 8191.
mepname - (Optional) Specify the MEP name.
<string 32> - Enter the MEP name. The maximum length is 32 characters.
Restrictions
None. (EI Mode Only Command)
Example
To display the CFM configuration:
DGS-3620-28SC:admin#show cfm
Command: show cfm
CFM State: Enabled
MD Index MD Name
---------- ----------------------
1 op_domain
DGS-3620-28SC:admin#

16-15 show cfm fault

Description
This command is used to display all the fault conditions detected by the MEPs contained in the
specified MA or MD. The display provides the overview of the fault status by MEPs.
Format
show cfm fault {md [<string 22> | md_index <uint 1-4294967295>] {ma [<string 22> |
ma_index <uint 1-4294967295>]}}
Parameters
md - (Optional) Specify the maintenance domain name.
<string 22> - Enter the maintenance domain name. The maximum length is 22 characters.
md_index - Specifies the maintenance domain index.
<uint 1-4294967295> - Enter the maintenance domain index value here. This value must
be between 1 and 4294967295.
ma - (Optional) Specify the maintenance association name.
<string 22> - Enter the maintenance association name. The maximum length is 22
Level
-----
2
251