D-Link xStack Reference Manual page 231

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
13-52 show bgp trap_state
Description
This command is used to show the BGP trap state.
Format
show bgp trap_state
Parameters
None.
Restrictions
None. (EI Mode Only Command)
Example
This example displays the BGP trap state:
DGS-3620-28SC:admin#
Command: show bgp trap_state
BGP Trap State
BGP Peer Established
BGP Peer Idle
DGS-3620-28SC:admin#
13-53 config bgp scan_timer
Description
This command is used to configure the BGP scan timer value. BGP will check the next hop
whether it is reachable from the BGP route before the timer expires.
Format
config bgp scan_timer [<sec 5-60> | default]
Parameters
<sec 5-60> - Set the BGP scan timer value from 5 to 60 seconds. Default is 60 seconds
default - Set the BGP scan timer to the default value.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
show bgp trap_state
:
: Enabled
: Enabled
226