D-Link xStack Reference Manual page 368

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
21-72 debug ripng show flag
Description
This command is used to display the RIPng debug flag setting.
Format
debug ripng show flag
Parameters
None.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
To show the current RIPng debug flag setting:
DGS-3620-28SC:admin# debug ripng show flag
Command: debug ripng show flag
Current Enabled RIPng Flags:
Interface State Change
Packet Receiving
Packet Sending
Route
DGS-3620-28SC:admin#
21-73 debug ripng state disable
Description
This command is used to disable the RIPng debug state.
Format
debug ripng state disable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
363