Dell Force10 Z9000 Reference Manual page 663

Parameters
environment
variable
Command Modes grub
Command History
Version 8.3.11.1
Usage The environment variables are listed under the list_env command. You must save the
Information environment variables before rebooting. The save_env command must be used for each
variable set using the set command.
Example
grub>save_env primary_boot
grub>
set
Sets the environment variables.
Z-Series
Syntax set [serverip=address | ipaddr=address | netmask=subnet-mask |
gatewayip = address | primary_boot='f10boot location' |
secondary_boot='f10boot location' | default_boot='f10boot
location' | macaddr=mac-address | baudrate=rate |
enablepwdignore | stdconfigignore}
Parameters
serverip
ipaddr
netmask
gatewayip
primary_boot
secondary_boot
default_boot
Enter the environment variable to be saved.
Introduced on the Z9000.
Set the IP address of the server.
Set the Management IP address of the unit.
Set the subnet mask of the Management IP address.
Set the IP address of the gateway.
Set the primary boot parameter. The location must be flash0, flash1 or
any valid tftp location. The primary boot parameter must be in the
following syntax:
set primary_boot='f10boot flash0 | flash1 |
tftp://ip-addr/file'
Set the secondary boot parameter. The location must be flash0, flash1
or any valid tftp location. The secondary boot parameter must be in
the following syntax:
set secondary_boot='f10boot flash0 | flash1 |
tftp://ip-addr/file'
Set the default boot parameter. The location must be flash0, flash1 or
any valid tftp location. The default boot parameter must be in the
following syntax:
663