Permit Tcp - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)
Hide thumbs Also See for Force10 Z9000:
Table of Contents

Advertisement

monitor
fragments
Defaults
Not configured.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST
Command History
Version 8.3.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.4.1.0
Version 6.5.10
Usage
The order option is relevant in the context of the Policy QoS feature only. For more
Information
information, refer to the Quality of Service chapter of the
When you use the log option, the CP processor logs details about the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may become
busy as it has to log these packets' details.
The monitor option is relevant in the context of flow-based monitoring only. For more
information, refer to

permit tcp

Configure a filter to pass TCP packets meeting the filter criteria.
C-Series, E-Series, S-Series, Z-Series
Syntax
permit tcp {source mask | any | host ip-address} [bit]
[operator port [port]] {destination mask | any | host ip-
address} [bit] [dscp] [operator port [port]] [count [byte] |
log] [order] [monitor] [fragments]
To remove this filter, you have two choices:
248
(OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring
section in the Port Monitoring chapter of the
Guide .
Enter the keyword fragments to use ACLs to control packet
fragments.
Added the keyword dscp.
Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Introduced on the E-Series ExaScale.
Added support for noncontiguous mask and added the monitor
option.
Expanded to include the optional QoS order priority for the ACL
entry.
Port
Monitoring.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
Use the no seq sequence-number command if you know the filter's sequence
number.
FTOS Configuration
FTOS Configuration Guide .

Advertisement

Table of Contents
loading

Table of Contents