Ip Pim Neighbor-Filter - Dell Force10 Z9000 Reference Manual

Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.7.1.0
Example
FTOS(conf)# ip access-list extended iptv-channels
FTOS(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
FTOS(config-ext-nacl)# permit ip any 232.1.1.0/24
FTOS(config-ext-nacl)# permit ip 100.1.1.0/16 any
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels in
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels out
Related ip access-list extended
Commands

ip pim neighbor-filter

Configure this feature to prevent a router from participating in protocol independent multicast (PIM).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-list}
command.
Parameters
access-list
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Usage Do not enter this command before creating the access-list.
Information
1134
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series for the port-channels and the S-Series.
Introduced on the E-Series.
– configure an access list based on IP addresses or protocols.
Enter the name of a standard access list. Maximum 16 characters.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.