Clear Hardware System-Flow; Hardware Watchdog - Dell Force10 Z9000 Reference Manual

clear hardware system-flow

Clear system-flow statistics from selected hardware components.
S-Series, Z-Series
Syntax clear hardware system-flow layer2 stack-unit 0-7 port-set 0-1
counters
Parameters
stack-unit
port-set
counters
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.0
Version 7.8.1.0
Related show hardware stack-unit
Commands statistics of the designated component of the designated stack member.

hardware watchdog

Set the watchdog timer to trigger a reboot and restart the system.
S-Series, Z-Series
Syntax hardware watchdog
Defaults Enabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.0
Version 7.8.1.0
Usage This command enables a hardware watchdog mechanism that automatically reboots an FTOS
Information switch/ router with a single unresponsive unit. This is a last resort mechanism intended to
prevent a manual power cycle.
580
0-7 Enter the keywords stack-unit followed by 0 to 7 to select a
particular stack member and then enter one of the following
command options to clear a specific collection of data.
0–1
Enter the keywords port-set along with a port-pipe number, from
0 to 1, followed by the keyword counters to clear the system-flow
counters on the selected port-pipe.
NOTE: S25 models (S25N, S25P, S25V, etc.) have only port-pipe 0.
Introduced on the Z9000.
Introduced on the S-Series.
– displays the data plane or management plane input and output
Introduced on the Z9000.
Introduced on the S-Series.