Fefd Reset - Dell Force10 Z9000 Reference Manual

Usage
If you enter only the fefd-global syntax, the mode is normal and the default interval is 15
Information
seconds.
If you disable FEFD globally (no fefd-global), the system does not remove the FEFD
interface configuration.
Related
Commands

fefd reset

Reset all interfaces or a single interface that was in "error-disabled" mode.
E-Series, Z-Series, S4810
Syntax fefd reset [interface]
Parameters
interface
Defaults Not configured.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.12.0
Legacy E-Series
command.
Related
Commands
952
• fefd – enables far-end failure detection.
• fefd-global interval – configures an interval between FEFD control packets.
• show fefdshow fefd – shows the FEFD command output.
(OPTIONAL) Enter the following keywords and slot/port or number
information:
•
•
•
•
•
Introduced on the Z9000.
Introduced on the S4810.
• fefd – enables far-end failure detection.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a SONET interface, enter the keyword sonet followed by
the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/ port information.