Ip Ecmp-Group; Ipv6 Ecmp-Deterministic - Dell Force10 Z9000 Reference Manual

ip ecmp-group

Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when maximum paths are
not configured, the CAM can hold a maximum of 16 ecmp per route.
Z-Series, S4810
Syntax ip ecmp-group {maximum-paths | {number} {path-fallback}
To negate a command, use the no ip ecmp-group maximum-paths {number}
command.
Parameters
maximum-paths
path-fallback
Defaults 16
Command Modes CONFIGURATION
Command History
Version 9.0.0.0
Version 8.3.10.0
Usage You must save the new ECMP settings to the startup-config (write-mem) then reload the
Information system for the new settings to take effect.
Related show ip cam stack-unit
Commands switch.

ipv6 ecmp-deterministic

Deterministic ECMP Next Hop arranges all ECMPs in order before writing them into the CAM.
E-Series
Syntax ipv6 ecmp-deterministic
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 8.3.1.0
Usage
For example, suppose the RTM learns eight ECMPs in the order that the protocols and
Information
interfaces came up. In this case, the FIB and CAM sort them so that the ECMPs are always
616
Specify the maximum number of ECMP for a route. The range is 2 to
64.
Use the keywords path-fallback to enable this feature. If you
enable the feature, re-enter this keyword to disable the feature.
Introduced on the Z9000.
Introduced on the S4810.
– Display content-addressable memory (CAM) entries for an S-Series
Introduced on the E-Series.