Neighbor Route-Reflector-Client; Network - Dell Force10 Z9000 Reference Manual

Command History
Version 7.4.1.0
Usage
When you apply a route map to outbound routes, only routes that match at least one section of
Information
the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in
the Route map used in this command. If you identify a peer by IP address, the Route map
overwrites either the inbound or outbound policies on that peer.

neighbor route-reflector-client

Configure a neighbor as a member of a route reflector cluster.
E-Series
Syntax neighbor {ipv6-address | peer-group-name} route-reflector-
client
To indicate that the neighbor is not a route reflector client or to delete a route reflector
configuration, use the no neighbor {ipv6-address | peer-group-name}
route-reflector-client command.
Parameters
ipv6-address
peer-group-name
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 7.4.1.0
Usage
The first time you enter this command it configures the neighbor as a route reflector and
Information
members of the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully
meshed if you configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.

network

Specify the networks for the BGP process and enter them in the BGP routing table.
E-Series
Syntax network ipv6-address [route-map map-name]
To remove a network, use the no network ip-address [route-map map-name]
command.
Introduced
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Enter the name of the peer group. All routers in the peer group
receive routes from a route reflector.
Introduced
525