Redistribute - Dell Force10 Z9000 Reference Manual

passive-interface default
no passive-interface interface
No passive-interface default

redistribute

Redistribute information from another routing protocol throughout the OSPF process.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax redistribute {connected | rip | static} [metric metric-value |
metric-type type-value] [route-map map-name] [tag tag-value]
To disable redistribution, use the no redistribute {connected | isis | rip |
static} command.
Parameters
connected
rip
static
metric
value
metric-type
value
• The previous no passive-interface interface is removed from the
running configuration.
• The ABR status for the router is updated.
• Save passive-interface interface into the running configuration.
• All present and future OSPF interface are marked as
• Any adjacency are explicitly terminated from all OSPF interfaces.
• All previous passive-interface interface commands are removed from the
running configuration.
• All previous no passive-interface interface commands are removed
from the running configuration.
• Remove the interface from the passive list.
• The ABR status for the router is updated.
• If passive-interface default is specified, then save no passive-
interface interface into the running configuration.
• Clear everything and revert to the default behavior.
• All previously marked passive interfaces are removed.
• May update ABR status.
Enter the keyword connected to specify that information from
active routes on interfaces is redistributed.
Enter the keyword rip to specify that RIP routing information is
redistributed.
Enter the keyword static to specify that information from static
routes is redistributed.
metric-
(OPTIONAL) Enter the keyword metric followed by a number. The
range is 0 (zero) to 16777214.
type-
(OPTIONAL) Enter the keywords metric-type followed by one of
the following:
• 1 = OSPF External type 1
passive .
1067