Dell Force10 Z9000 Reference Manual page 933

Column Heading
Type
Interface
State
Example
FTOS#show mac-address-table
VlanId Mac Address
999
999
FTOS#
Usage The following describes the show mac-address-table count command shown in the
Information
Example below.
Line Beginning With
MAC Entries...
Dynamic Address...
Static Address...
Total MAC...
Example (Count)
FTOS# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count :
Static Address (User-defined) Count : 0
Sticky Address Count :
Total Synced Mac from Peer(N):
Total MAC Addresses in Use:
FTOS#
Related show mac-address-table aging-time
Commands
Description
Lists whether the MAC address was manually configured (Static),
learned dynamically (Dynamic), or associated with a specific port
(Sticky).
Displays the interface type and slot/port information. The following
abbreviations describe the interface types:
• gi — Gigabit Ethernet followed by a slot/port.
• po — Port Channel followed by a number. The range is 1 to
255 for TeraScale.
• so — Sonet followed by a slot/port.
• te — 10-Gigabit Ethernet followed by a slot/port.
Lists if the MAC address is in use (Active) or not in use (Inactive).
00:00:00:00:00:19 Sticky
00:00:00:00:00:29 Dynamic Gi 0/2
Description
Displays the number of MAC entries learnt per VLAN.
Lists the number of dynamically learned MAC addresses.
Lists the number of user-defined MAC addresses.
Lists the total number of MAC addresses used by the switch.
– displays MAC aging time.
Type Interface State
Gi 0/1 Active
Active
110
0
100
110
933