Ip Multicast-Routing; Mac-Flood-List - Dell Force10 Z9000 Reference Manual

Related show ip igmp groups
Commands

ip multicast-routing

Enable IP multicast forwarding.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip multicast-routing
To disable multicast forwarding, use the no ip multicast-routing command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.7.0
E-Series legacy
command
Usage
You must enter this command to enable multicast on the E-Series.
Information
After you enable multicast, you can enable IGMP and PIM on an interface. In INTERFACE
mode, enter the ip pim sparse-mode command to enable IGMP and PIM on the
interface.
Related ip pim sparse-mode
Commands

mac-flood-list

Provide an exception to the restrict-flood configuration so that multicast frames within a specified MAC address range
to be flooded on all ports in a VLAN.
E-Series
Syntax mac-flood-list mac-address mask vlan vlan-list [min-speed
speed]
Parameters
mac-address
mac-mask
vlan
1012
– shows the IGMP groups.
Introduced on the S4810.
– enables IGMP and PIM on an interface.
Enter a multicast MAC address in hexadecimal format.
Enter the MAC Address mask.
vlan-list
Enter the VLAN(s) in which flooding is restricted. Separate values by
commas — no spaces (1,2,3) or indicate a list of values separated by
a hyphen (1-3). The range is 1 to 4094.