Debugging and Diagnostics
The debugging and diagnostics commands are supported on the Dell Force10 C-Series, E-Series, S-Series, and Z-Series
platforms.
This chapter contains the following sections:
•
Diagnostics and Monitoring Commands
•
Offline Diagnostic Commands
•
Buffer Tuning Commands
•
Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the
logging coredump
Enable coredump.
C-Series, E-Series, S-Series, Z-Series
Syntax
logging coredump {cp | linecard {number | all} | rps}
Parameters
cp
linecard
rps
Defaults
The kernal coredump is enabled by default for RP 1 and 2 on the E-Series. The kernel coredump
for CP and application coredump are disabled on all systems by default.
Command Modes
CONFIGURATION
Command History
Version 8.3.11.1
Version 7.7.1.0
Version 6.5.1.0
Version 6.1.1.0
Control and Monitoring
chapter.
Enable coredump for the CP.
Enable coredump for a linecard.
Enable coredump for RP 1 and 2.
Introduced on the Z9000.
Restructured the command to accommodate core dumps for CP.
Introduced on the C-Series and S-Series.
Application coredump naming convention enhanced to include
application.
Introduced
12
567