Debug Gvrp - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

debug gvrp

Enable debugging on GVRP.

C-Series, E-Series, S-Series, Z-Series, S4810

debug gvrp {config | events | pdu}

To disable debugging, use the no debug gvrp {config | events | pdu}

Command Modes

Command History

Version 8.3.11.1

Version 8.3.7.0

Version 7.6.1.0

Enter the keyword config to enable debugging on the GVRP

configuration.

Enter the keyword event to enable debugging on the JOIN/LEAVE

events. Not available on the S4810.

Enter the keyword pdu followed one of the following Interface

keywords and slot/port or number information:

Not available on the S4810.

For a Fast Ethernet interface, enter the keyword

FastEthernet followed by the slot/port information.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a Port Channel interface, enter the keywords port-

channel followed by a number. For the C-Series and S-

Series, the range is 1 to 128. For the E-Series, the range is 1 to

255 for TeraScale and 1 to 512 for ExaScale.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by the slot/port information.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on C-Series, E-Series, and S-Series