Network Backdoor - Dell Force10 Z9000 Reference Manual

Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage The E-Series software resolves the network address configured by the network command
Information
with the routes in the main routing table to ensure that the networks are reachable via non-
BGP routes and non-default routes.
Related redistribute
Commands

network backdoor

Specify this IGP route as the preferred route.
C-Series, E-Series
Syntax network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length
backdoor command.
Parameters
ipv6-address
prefix-length
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage Though FTOS does not generate a route due to backdoor config, there is an option for injecting/
Information sourcing a local route in presence of network backdoor config on a learned route.
496
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all
routes).
Introduced on the E-Series ExaScale.
Introduced
– redistributes routes into BGP.
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The r range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Introduced on the E-Series ExaScale.
Introduced