Network - Dell Force10 Z9000 Reference Manual

To remove a weight value, use the no neighbor {ipv6-address | peer-group-
name} weight weight command.
Parameters
ipv6-address
peer-group-name
weight
Defaults 0
Command Modes ROUTER BGP
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage In the FTOS best path selection process, the path with the highest weight value is preferred.
Information

network

Specify the networks for the BGP process and enter them in the BGP routing table.
C-Series, E-Series
Syntax network ipv6-address prefix-length [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-
name] command.
Parameters
ipv6-address
prefix-length
mask
route-map
name
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Enter the name of the peer group to disable all routers within the peer
group.
Enter a number as the weight. The range is 0 to 65535. The default is
0.
Introduced on the E-Series ExaScale.
Introduced
NOTE: Reset the neighbor connection (the clear ip bgp * command) to apply the
weight to the connection and recompute the best path.
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Enter the mask of the IP address in the slash prefix length format (for
example, /24). The mask appears in command outputs in dotted
decimal format (A.B.C.D).
map-
(OPTIONAL) Enter the keywords
an established route map. Only the following ROUTE-MAP mode
commands are supported:
•
•
route-map followed by the name of
match ipv6 address
match ipv6 next-hop
495