Interfaces; Basic Interface Commands; Clear Counters - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

Interfaces

The commands in this chapter are supported by Dell Force10 operating software (FTOS) on the E-Series, C-Series, S-

Series, S4810, or Z-Series platforms.

Although all interfaces are supported on E-Series ExaScale, some interface functionality is supported on E-Series

ExaScale with FTOS 8.2.1.0 and later. When this is the case, it is noted in the Command History section.

This chapter contains the following sections:

Port Channel Commands

Time Domain Reflectometer (TDR)

UDP Broadcast

Basic Interface Commands

The following commands are for Physical, Loopback, and Null interfaces.

Clear the counters used in the show interfaces commands for all virtual router redundancy protocol (VRRP) groups,

virtual local area networks (VLANs), and physical interfaces, or selected ones.

C-Series, E-Series, S-Series, Z-Series, S4810

clear counters [interface] [vrrp [{[ipv6] vrid | vrf instance}]

| learning-limit]

(OPTIONAL) Enter any of the following keywords and slot/port or

number to clear counters from a specified interface:

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a Loopback interface, enter the keyword loopback

followed by a number from 0 to 16383.

For a Port Channel interface, enter the keywords port-

channel followed by a number. For the C-Series and S-

Series, the range is 1 to 128. For the E-Series, 1 to 255 for

TeraScale and 1 to 512 for ExaScale.