Usage
The access list accepted is an extended ACL. Use this feature to block IGMP reports from
Information
hosts, on a per-interface basis based on the group address and source address that you
specify in the access list.
ip igmp group-join-limit
Use this feature to limit the number of IGMP groups that can be joined in a second.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip igmp group-join-limit number
Parameters
number
Defaults
none
Command Modes
CONFIGURATION (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
ip igmp immediate-leave
Enable IGMP immediate leave.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip igmp immediate-leave [group-list prefix-list-name]
To disable ip igmp immediate leave, use the no ip igmp immediate-leave
command.
Parameters
group-list
list-name
Defaults
Not configured.
Command Modes
INTERFACE
670
Enter the number of IGMP groups permitted to join in a second. The
range is 1 to 10000.
interface-slot/port )
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
prefix-
Enter the keywords group-list followed by a string up to 16
characters long of the prefix-list-name.