Policy-Aggregate - Dell Force10 Z9000 Reference Manual

Usage You must enter the class-map command in order to access this command. You can match
Information against only one VLAN ID.
Related class-map
Commands

policy-aggregate

Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policy
map (input/output) applied on an interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate qos-
policy-name command.
Parameters
qos-policy-name
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output)
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage
C-Series and S-Series
Information
Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic. Aggregate
input/output QoS policy can coexist with per queue input/output QoS policies.
E-Series
– identifies the class map.
Enter the name of the policy map in character format (32 characters
maximum).
Introduced on the Z9000.
Introduced on the S4810.
Policy name character limit increased from 16 to 32.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1. If only aggregate input QoS policy exists, input traffic conditioning configurations (rate-
police) apply. Any marking configurations in aggregate input QoS policy are ignored.
2. If aggregate input QoS policy and per class input QoS policy coexist, aggregate input QoS
policy preempts per class input QoS policy on input traffic conditioning (rate-police). In
other words, if rate police configuration exists in the aggregate QoS policy, the rate
police configurations in per class QoS are ignored. Marking configurations in per class
input QoS policy still apply to each queue.
1201