Port-Channel Failover-Group; Show Config - Dell Force10 Z9000 Reference Manual

port-channel failover-group

Access PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG failover group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group
command.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Usage
This feature groups two LAGs to work in tandem as a supergroup. For example, if one LAG goes
Information
down, the other LAG is taken down automatically, providing an alternate path to reroute traffic,
avoiding oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs
to configure failover groups. For more information, refer to the "Port Channel" chapter in the
FTOS Configuration Guide .
Related
group
Command
show interfaces port-channel

show config

Display the current configuration of the selected LAG.
C-Series, E-Series, S-Series, Z-Series
Syntax show config
Command Modes INTERFACE PORTCHANNEL
Command History
Version 8.3.11.1
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
– groups two LAGs in a supergroup ("fate-sharing group").
– displays information on configured Port Channel groups.
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
757