Neighbor Ebgp-Multihop; Neighbor Fall-Over - Dell Force10 Z9000 Reference Manual

Version 7.7.1.0
Usage Other BGP filtering commands include: neighbor filter-list, ip as-path
Information access-list, and neighbor route-map.
Related
ip as-path access-list
Commands
neighbor filter-list
neighbor route-map

neighbor ebgp-multihop

Attempt and accept BGP connections to external peers on networks that are not directly connected.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax neighbor {ip-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ip-address |
peer-group-name} ebgp-multihop command.
Parameters
ip-address
peer-group-name
ttl
Defaults Disabled.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage To prevent loops, the neighbor ebgp-multihop command does not install the default
Information
routes of the multihop peer. Networks not directly connected are not considered valid for best-
path selection.

neighbor fall-over

Enable or disable fast fall-over for BGP neighbors.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax neighbor {ipv4-address | peer-group-name} fall-over
To disable, use the no neighbor {ipv4-address | peer-group-name} fall-
over command.
364
Introduced on the C-Series.
– configures IP AS-Path ACL.
– assigns a AS-PATH list to a neighbor or peer group.
– assigns a route map to a neighbor or peer group.
Enter the IP address of the neighbor in dotted decimal format.
Enter the name of the peer group.
(OPTIONAL) Enter the number of hops as the Time to Live (ttl) value.
The range is 1 to 255. The default is 255.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.