Bgp Log-Neighbor-Changes - Dell Force10 Z9000 Reference Manual

Parameters
neighbor
address | peer-
group-name
restart-time
seconds
stale-path-time
seconds
role receiver-only
Defaults As above.
Command Modes ROUTER BGP
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage This feature is advertised to BGP neighbors through a capability advertisement. In Receiver
Information Only mode, BGP saves the advertised routes of peers that support this capability when they
restart.

bgp log-neighbor-changes

Enable logging of BGP neighbor resets.
C-Series, E-Series
Syntax bgp log-neighbor-changes
To disable logging, use the no bgp log-neighbor-changes command.
Defaults Enabled.
Command Modes ROUTER BGP
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage The bgp log-neighbor-changes command appears in the show config command
Information
output.
Related show config
Commands
ip-
Enter the keyword neighbor followed by one of the options listed
below:
• ip-address of the neighbor in IP address format of the
neighbor.
• peer-group-name of the neighbor peer group.
Enter the keywords restart-time followed by the maximum
number of seconds needed to restart and bring up all peers. The
range is 1 to 3600 seconds. The default is 120 seconds.
Enter the keywords stale-path-time followed by the maximum
number of seconds to wait before restarting a peer's stale paths. The
default is 360 seconds.
Enter the keywords role receiver-only to designate the local
router to support graceful restart as a receiver only.
Introduced on the E-Series ExaScale.
Introduced
Introduced on the E-Series ExaScale.
Introduced
– views the current configuration.
463