disable
Disable PVST+ globally.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
disable
To enable PVST+, use the no disable command.
Defaults
Disabled.
Command Modes
CONFIGURATION (conf-pvst)
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Related
protocol spanning-tree pvst
Commands
extend system-id
Use extend system ID to augment the Bridge ID with a VLAN ID so that PVST+ differentiate between BPDUs for each
VLAN. If for some reason on VLAN receives a BPDU meant for another VLAN, PVST+ will then not detect a loop, and
both ports can remain in forwarding state.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
extend system-id
Defaults
Disabled
Command Modes
PROTOCOL PVST
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Example
FTOS(conf-pvst)#do show spanning-tree pvst vlan 5 brief
VLAN 5
Executing IEEE compatible Spanning Tree Protocol
Root ID Priority 32773, Address 0001.e832.73f7
Root Bridge hello time 2, max age 20, forward delay 15
1168
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enter PVST+ mode.
Introduced on the Z9000.
Introduced on the S4810.
Introduced.